Merlin, Installation – Maximum Merlin User Manual

Page 2

Page 2

30 Barnet Boulevard

New Bedford, MA 02745

(508) 995-2200

MERLIN

INSTALLATION

(continued)

Follow the instructions supplied with the antenna
mount and secure the mast to the mount.

Feed the cables through the wall to where the read-out is going to
be located. Attach the wires to the rear of the read-out as shown.
The red wire from the direction sensor cable connects to terminal #4.
the green wire to terminal #5. Connect the black and white wires
from the speed sensor to terminals #1 and #2. The polarity does
not matter.

le shield itself is not connected, shielded

Although the cab

cable m

Connect the wires from the AC adapter to the

ust be used.

meter

ity does not matter

. The polar

. (Do NOT adjust the nuts that

are already on the meter).

Mount the br

ver the cable feed-thr

ass read-out directly o

u-hole

to avoid crimping the wire under the lip. We recommend mounting
the read-out on one of our pre-drilled and centered panels. Plug the
power supply into a 110 VAC power outlet.

8 FEET

CHIMNEY

MOUNT

VENT-PIPE

MOUNT

TRIPOD

MOUNT

WALL

MOUNT

EVE

MOUNT

CABLE-HOLE

ALL

Secure the wire to the building using cable clips (do not use regular
staples). Form a drip loop where the wires enter the hole drilled
through the exterior wall. Caulk the hole when done.

DRIP

LOOP

FROM AC
ADAPTER

BRASS

NUTS

CAULK

WIRE

CABLE

CLIPS

When Merlin first starts up it will
perform a brief self-test and then
go to the "Present" function mode.

Reset all memory functions (see operating instructions).
Resetting gives Merlin a fresh starting point for your
reference.

SCREW

PANEL

GREEN

WIRE

RED

WIRE

Select Units of

Measurment

AC ADAPTOR

(NO POLARITY)