Campbell Scientific ET107 Evapotranspiration Monitoring Station User Manual
Instruction manual, Et107 weather station
Table of contents
Document Outline
- Revision and Copyright Information
- Limited Warranty
- Assistance
- Table of Contents
- 1. Preparation and Siting
- 2. Hardware Installation
- 2.1 Base Foundation
- 2.2 Tower/Pole
- 2.3 Enclosure
- 2.4 Crossarm and Sensor Installation
- 2.4.1 Components
- 2.4.2 Crossarm Installation
- 2.4.3 RH and Temperature Radiation Shield
- 2.4.4 034B Wind Sensor (Wind Sensor Option –MW)
- 2.4.5 Gill WindSonic 2-D Ultrasonic Wind Sensor (Wind Sensor Option –GW)
- 2.4.6 Rain Gage
- 2.4.7 Pyranometer
- 2.4.8 107-LC or 108-LC Soil Temperature Sensor (Optional)
- 2.4.9 CS616-LC Water Content Sensor (Optional)
- 2.4.10 CS650-LC or CS655-LC Soil Water Content Sensor Plus (Optional)
- 2.4.11 Sensor Connections
- 2.4.12 Sensor Verification and Clock Set
- 2.5 Communication Peripherals
- 2.6 Lightning Rod Installation
- 2.7 Solar Panel Installation
- 2.8 Battery Installation
- 2.9 Restraining Cables and Sealing/Desiccating Enclosure
- 3. ET Software
- 4. Maintenance, Troubleshooting, and Schematics
- 4.1 Maintenance
- 4.2 Troubleshooting
- 4.2.1 No Response Using the CR1000KD Keypad
- 4.2.2 No Response from Datalogger through SC32B, RAD Modem, or Phone Modem
- 4.2.3 NAN or (INF Displayed in a Variable
- 4.2.4 Unreasonable Results Displayed in a Variable
- 4.2.5 NAN or (INF Stored in a Data Table
- 4.2.6 Communication Problems when using an RF450 Radio
- 4.2.7 Gill WindSonic1-ET Diagnostic Diagnostic Codes
- 4.3 Schematics of Connectors
- Appendix A. ET107 Maintenance Log
- Appendix B. PS24 24 Ahr Power Supply and 10 x 12 inch Enclosure
- Appendix C. Exploded Views
- Appendix D. Default Programs
- Appendix E. Step-down Transformer Installation
- Campbell Scientific Companies