Campbell Scientific CVS4200 / BVS4300 Stationary Samplers - Manual (Page 80)

CVS4200 / BVS4300 Stationary Samplers
7.6.8.2 Viewing Generated Information
The following sequence of entries are made on the Touchpad to examine the
sample information collected or generated by the controller and stored in its
memory.
SAMPLES TAKEN
Press the VIEW key.
Press the SAMPLES TAKEN key.
The display will show a count of all samples taken
during the current program. To make these changes
active, press the RESTART key; press it again to
confirm your choice. The controller will then wait
until the designated time before starting its
sampling program.
REMAINING PULSES
Press the VIEW key.
Press the REMAINING PULSES key.
The display will show a countdown of incoming
pulses, decreasing from the programmed value.
Only available when either START DELAY or
SAMPLE INITIATION are using their Pulse
Input options or pulses generated by the 4-20mA
input option. The information is updated
continuously and can be left on the display as a
progress indicator.
Sequence: VIEW, REMAINING PULSES.
REMAINING TIME
Press the VIEW key.
Press the REMAINING TIME key.
The display will show various time counters
dependent on the programming of the START
DELAY and SAMPLE INITIATION parameters.
Priority goes to START DELAY, which will show
an incrementing time for event related delays or
decrementing time for time related delays. The
display will then yield to SAMPLE INITIATION
for an elapsed time display for event related inputs
and Remaining Time display for time related
inputs.
Sequence: VIEW, REMAINING TIME.
72