Campbell Scientific CVS4200 / BVS4300 Stationary Samplers - Manual (Page 77)

CVS4200 / BVS4300 Stationary Samplers
The display will show the response
“FAULT SHUTDOWN Enabled /
Disabled”. All the characters on the bottom
line are flashing, therefore the choice is
made with the ARROW keys. The choice
is a toggle between ‘Enabled’ or
‘Disabled’. If disabled, the controller will
make a lengthy attempt to obtain a sample,
then return control to the SAMPLE
INITIATION to try again. The controller
will accumulate a count of unsuccessful
(abandoned) attempts.
Press ENTER. The display now reads
FAULT SHUTDOWN .
The controller has now been given a new
value for FAULT SHUTDOWN. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key;
press it again to confirm your choice. The
controller will then be set to perform in
conjunction with the parameters
programmed under the START DELAY,
SAMPLE INITIATION and PROGRAM
TYPE settings.
Summary of Sequence:
SET, OTHER OPTIONS, ARROW(S), ENTER, ARROW(S), ENTER,
RESTART, RESTART.
7.6.8 Viewing Information
7.6.8.1 Viewing Programmed Information
To see current settings, press the VIEW button,
followed by the appropriate button as described on
its label.
The display will show current parameter settings,
beginning with the requested major category.
69