Campbell Scientific CSAT3 3-D Sonic Anemometer - Manual (Page 44)

CSAT3 Three Dimensional Sonic Anemometer
;Configure CSAT3 with 10 Hz parameters.
;
12: SDM-CSAT3 (P107)
1: 1 Reps
2: 3 SDM Address
3: 10 Set Execution Parameter
4: 1 Ux Input Location [ Ux ]
13: End (P95)
14: End (P95)
15: End (P95)
16: End (P95)
;Each diagnostic flag, that is encoded in the diagnostic word
;(diag), is assigned an Input Location. These Input Locations
;serve as flags and take on values of one or zero.
;
17: Beginning of Subroutine (P85)
1: 2 Subroutine 2
;Set the flags low (set each "flag's" input location = 0) before
;recording the number of samples, Not a Number (NaN), or diagnostic
;flags that were on.
;
18: Block Move (P54)
1: 7 No. of Values
2: 19 First Source Loc [ zero ]
3: 1 Source Step
4: 20 First Destination Loc [ smpls ]
5: 1 Destination Step
19: If Flag/Port (P91)
1: 19 Do if Flag 9 is High
2: 30 Then Do
;Set "NaN" flag.
;
20: Z=F (P30)
1: 1 F
2: 0 Exponent of 10
3: 21 Z Loc [ NaN_csat ]
21: Else (P94)
;Set "sample used" flag.
;
22: Z=F (P30)
1: 1 F
2: 0 Exponent of 10
3: 20 Z Loc [ smpls ]
23: End (P95)
34