Aalborg Vortex Insertion - Manual (Page 91)

86
COMMAND
NAME
DESCRIPTION
NO.
COMMAND SYNT
A
X
COMMAND
ARGUMENT 1
ARGUMENT 2
ARGUMENT 3
ARGUMENT 4
RESPONSE
To
talizers
Sets and controls action of the flow T
o
talizers.
NOTE: Start totalizer at Flow value has to be entered for V
o
lumetric
and Mass flow conditions in fraction %FS notation (0.0 – 1.0) Limit volume has to be entered: -for V
o
lumetric flow conditions
in currently selected volume EU -for Mass flow conditions in currently selected mass EU If T
o
talizer hit limit event is not
required, set “Limit V
o
lume”
value (argument 4) to zero. To
talizers reading is stored in
EEPROM (non volatile) memor
y. Power cycle will not
affect T
o
talizers reading.
12
T
1 (T
otalizer #1)
2 (T
otalizer #2)
Z (Reset to zero)
T1Z or T2Z
V – V
o
lumetric.
Flow Condition
(start totalizer at flow) Fraction %FS not. (0.0 – 1.0)
(Limit volume in current V
o
lumetric E.U.)
T1V
:0.1, 0.0
or T2V
:0.1, 0.0
M – Mass. Flow Condition
(start totalizer at flow) Fraction %FS not. (0.0 – 1.0)
(Limit volume in current Mass based E.U.)
T1M:0.1, 0.0 or T2M:0.1, 0.0
D (disable totalizer)*
T1:D or T2:D
E (enable totalizer)
T1:E or T2:E
R (read current totalizer volume)
T1R: or T2R: (in current EU)
S (setting status)
T1S:Mode,Condition,StartFl ow
,LimitV
olume
or T2S:Mode,Condition,StartFl ow
,LimitV
olume