Aalborg Vortex Insertion - Manual (Page 105)

100
UART Error Codes:
1 - Not Supported Command or Back Door is not enabled.
2 - Wrong # of Arguments.
3 - Address is Out of Range (MR or MW commands).
4 - Wrong # of the characters in the Argument.
5 - Attempt to Alter Write Protected Area in the EEPROM.
6 - Proper Command or Argument is not found.
7 - Wrong value of the Argument.
8 - Reserved.
9 - Manufacture specific info EE KEY (wrong key or key is disabled).
Diagnostic and System events codes and bit position:
Code Event Description Bit position
0 CPU Temp. High 0x0000001
1 Freq > HiLimit 0x0000002
2 High Flow Alm. 0x0000004
3 Low Flow Alarm 0x0000008
4 High Temp Alm. 0x0000010
5 Low Temp Alm 0x0000020
6 High Pres Alm. 0x0000040
7 Low Press Alm. 0x0000080
8 Tot#1 > Limit 0x0000100
9 Tot#2 > Limit 0x0000200
10 OptPulse Queue 0x0000400
11 Flow Turbulen. 0x0000800
12 Flow < Cut Off 0x0001000
13 Event Log Over 0x0002000
14 Data Log Over. 0x0004000
15 System L Event 0x0008000
System Events:
16 PEZO SENS. FAULT 0x0010000
17 TEMP SENS. FAULT 0x0020000
18 PRES SENS. FAULT 0x0040000
19 SER. COMM. ERROR 0x0080000
20 EEPROM ACC ERROR 0x0100000
21 BATTERY FAILURE 0x0200000
22 POWER ON EVENT 0x0400000
23 PASSWORD EVENT 0x0800000
24 FATAL ERROR 0x1000000