MagTek Bluetooth MagneSafe V5 Swipe Reader - Manual (Page 34)

Bluetooth MagneSafe V5 Swipe Reader
26
TRACK ID ENABLE PROPERTY
Property ID: 0x05
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x95
Description: This property is defined as follows:
id 0 T
3
T
3
T
2
T
2
T
1
T
1
Id 0 – Decodes standard ISO/ABA cards only
1 – Decodes AAMVA and 7-bit cards also
If this flag is set to 0, only tracks that conform to the ISO format allowed for that
track will be decoded. If the track cannot be decoded by the ISO method it will
be considered to be in error.
T
#
00 – Track Disabled
01 – Track Enabled
10 – Track Enabled/Required (Error if blank)
This property is stored in non-volatile memory, so it will persist when the unit is
power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled for these changes to take effect. To
properly power cycle this reader, it must be unplugged for at least 30 seconds.
Example Set Track ID Enable property Request (Hex):
Cmd Num Data Len Prp ID Prp Value
01 02 05 95
Example Set Track ID Enable property Response (Hex):
Result Code Data Len Data
00 00
Example Get Track ID Enable property Request (Hex):
Cmd Num Data Len Prp ID
00 01 05
Example Get Track ID Enable property Response (Hex):
Result Code Data Len Prp Value
00 01 95
ISO TRACK MASK PROPERTY
Property ID: 0x07
Property Type: String
Length: 6 bytes
Get Property: Yes
Set Property: Yes
Default Value: ”04040Y”