Videotec NTC - Manual (Page 9)

Instruc
tions manual - English - EN
7
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Unpacking and contents
5.1.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Allen wrench
• Spacers
• Clamp
• Silicon sheath
• Screws and washers
• Screws for camera
• Instructions manual
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.
6 Assembling and installing
Only specialised personnel should be
allowed to assemble and install the device.
6.1 Installation
6.1.1 How to open the housing
To open the housing, unscrew the bolts on the rear
flange, using the allen wrench supplied.
Fig. 1
Slide out the rear cover plate of the housing, taking
care to leave the sealing washer in its seating.
Fig. 2