Holtkoetter 5907 - Manual (Page 2)

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks
of Holtkötter International, Inc. All Rights Reserved.
© Holtkötter International, Inc.
HOLTKÖTTER INTERNATIONAL, INC.
www.holtkoetter.com
e-mail: [email protected]
ASSEMBLY INSTRUCTIONS FOR
Fixture Height Adjustment
(Diagram 3)
The center bar (H) between the canopy and
the fixture can be raised or lowered to adjust the
overall height of the fixture.
Press the knobs (J) at each end of the center
bar simultaneously to raise or lower the fixture to
the desired height.
Install the Acrylic Shade & Bulbs
(Diagram 4)
Set the acrylic reflector (K) on the fixture. 1.
Lightly fingter-tighten the finished flat-
head screws (L) on the fixture, allowing the
acrylic reflector room to move.
Fine tune the position of the acrylic reflector
2.
on the fixture by making adjustments so that
each socket is centered in the acrylic
reflector. Exact placement of the reflector
is essential.
Using the allen wrench (N) provided, screw
3.
each finished flat-head screw (L) onto the
fixture until it is snug.
The bulbs provided
4.
with this fixture are
specialty
low-voltage
bulbs by Osram,
the Halostar Starlite.
Insert the bulbs (M)
into
the sockets.
NOTE: BE CAREFUL NOT TO TOUCH
THE BULB WITH YOUR BARE HANDS.
CAUTION: Always remember to disconnect
power to the fixture before replacing bulbs
to prevent damage to the bulbs. Diagram 4
Diagram 2
Diagram 3
K
L
M
N
Mounting Instructions (Diagram 1)
Parts used:
Round 5” decorative plate with A.
universal crossbar
Long metal strap with screws
B.
Two brass tubular nuts C.
Two decorative knobs D.
Disconnect power to the box before 1.
installation.
Remove decorative knobs (D) and the
2.
brass tubular nuts (C) that are located
under the decorative knobs (D).
Remove the long metal strap (B) located
3.
on the top of canopy.
Mount the round decorative plate (A) to
4.
the metal strap with screws provided on
the universal crossbar strap, then mount
the assembled piece to the outlet box.
Connect the wires from the fixture with
5.
the wires in the outlet box according to
generally accepted electrical standards,
then slide the canopy over the metal strap
and secure with brass tubular screws (C).
Finally put decorative knobs (D) on the
6.
bottom of the canopy.
Shorten Fixture Cable (Diagram 2)
This low-voltage pendant cannot be lengthened in the field. Due to the
nature of this support system, fixtures requiring longer support cables will
have to be special ordered.
Take the weight off the fixture and lift the 1.
finished cable cover (E).
Pull enough cable (G) through the cable
2.
guide (F) to correct the height. Cut the
cable (G) off to the correct length.
Replace the finished cable cover (E).
3.
Low-voltage Halogen Pendant
No. 5907/7
Diagram 3
H
Diagram 2
E
G
F
M
Diagram 1
C
D
A
B
J