Holtkoetter 6506 User Manual

Mini desk lamp no. 6506, Assembly instructions for, Important safety instructions

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Mini Desk Lamp

No. 6506

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.

Please make sure that the following parts for your lamp are enclosed:
1. Lamp Base
2. Reflector kit including:

Glass Reflector with set screw

Frosted glass shield

60 Watt Clear Halopin bulb, G9 Base

Allen Wrench (packed inside the bulb box)

Bulb Installation & Reflector Assembly

1. Install the bulb (C) in the socket by pushing it straight down into the socket. See Diagram A.
2. Set the glass shield (B) on the grooved counterpart of the reflector (A). See Diagram B.
3. Place the reflector (A) on the base over the bulb. Locate the set screw on the reflector and

tighten it with the allen wrench (D). It may be necessary to lift the glass shield slightly to allow
the set screw to turn.

4. Plug lamp into your outlet. The lamp is now operational. The switch on the cord can be set

at high, low or off.

UL REQUIRES THE FOLLOWING INSTRUCTIONS PERTAINING TO THE RISK OF FIRE,
ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV RADIATION OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS

Lighted lamp is HOT!
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, EXPOSURE TO
EXCESSIVE RADIATION OR INJURY TO PERSONS, READ, FOLLOW AND SAVE
THESE INSTRUCTIONS:

1. Before replacing bulb, UNPLUG lamp and allow bulb to cool.
2. Bulb gets hot quickly. Only contact switch/plug when turning on.
3. DO NOT touch hot glass shield.
4. Do not remain in light if skin feels warm.
5. Do not look directly at a lighted bulb.
6. Keep lamp away from materials that may burn.
7. Use only with a 60 Watt bulb or smaller.
8. Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb.
9. Do not operate lamp with a missing glass shield.

Diagram A

Diagram B