Holtkoetter 2573 - Manual

205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Halogen Torchiere
No. 2573
Congratulations, you have purchased one of the finest
brass torchieres available on the market today.
Complete with safety features such as a fully enclosed
bulb compartment and a tilt switch, this torchiere comes
with peace of mind.
The following parts are included with the torchiere:
1. Torchiere Glass Shade
2. Torchiere Glass Shield assembly (including finished
knob and white plastic washers)
3. Allen wrench for Torchiere Glass Shield (packed inside
bulb box)
4. 100-Watt frosted Bayonet Base Halogen bulbs,
3 each.
Note of Caution: The recommended replacement
bulbs for the torchiere on this fixture are 100-Watt
Osram Bayonet Base Halogen bulbs. Use of other
brands of unknown quality may cause a risk of
overheating.
CARE INSTRUCTIONS
Use only a soft, dry cloth to clean. If necessary, a slightly
damp, soft cloth may be used to spot clean.
Do not use common household cleaners or brass cleaners
on lamps or fixtures, as the lacquer on the outside of the
brass may be damaged as a result.
Enjoy your new Holtkötter lamp.
INSTALL THE TORCHIERE GLASS SHADE AND BULBS
1. Unscrew the three white knobs and
remove the white ring. 2. Install the glass shade, replacing
the white ring and tightening the three
white knobs hand-tight. Be sure not to
overtighten the knobs.
3. Being careful not to touch the bulb
envelope with your bare hands, install
the three bayonet base bulbs provided.
Push the bulb into the socket and turn
clockwise. 4. Place the glass shield assembly
over the center stem of the torchiere,
concave side up. Tighten with the allen
wrench provided. Your torchiere is now
operational.