Holtkoetter 5403 User Manual

Ceiling fixture no. 5403, Assembly instructions for

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Ceiling Fixture

No. 5403

Please make sure that the following parts for ceiling fixture are enclosed:

1. Fixture including crossbar strap
2. Glass shade
3. Bulbs: 3x 60 Watt Halopin, Frosted by Osram. Order Code: 9250*060-HPNFR

Be sure to turn off the circuit breaker before installing this fixture. It is
recommended that this fixture be installed and hung by a licensed
electrician.

Mounting Instructions & Diagram

1. Disconnect power to the outlet box before installation.
2. Locate and loosen the two phillips screws (B) to release fixture from the crossbar strap

(A). Turn fixture counter-clockwise to release. NOTE: DO NOT REMOVE THE SCREWS

COMPLETELY.

3. Mount the crossbar strap (A) to the

outlet box.

4. Connect the wires from the fixture

according to generally accepted

electrical standards.

5. Align the notches in the fixture (C)

with the screws (B) loosened in Step 2.

Push the fixture up and turn clockwise

to install it on the crossbar strap (A).

6. To secure the fixture to the crossbar

strap, tighten the two screws (B).

7. Install the bulbs (D), by pushing them

straight into the sockets (E).

8. To install the glass (G), put it on the

fixture (C) and turn each socket (E)

outwards. This will allow enough room

for the three-prong spanner (F) to be

put in place. Secure spanner (F) with

the aluminum stem (H) by screwing

the stem (H) into place.

9. Complete the fixture by screwing the finished glass cover plate (J) onto the aluminum

stem (H).

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter fixture.