Holtkoetter 5402 User Manual

Ceiling fixture no. 5402, Assembly instructions for

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Ceiling Fixture

No. 5402

Please make sure that the following parts for ceiling fixture are enclosed:

1. Fixture including crossbar strap

2. Glass shade

3. Bulb: 75 Watt Halopin, Frosted by Osram. Order Code: 9250*075-HPNFR

Be sure to turn off the circuit breaker before installing this fixture.
It is recommended that this fixture
be installed and hung by a licensed
electrician.

Mounting Instructions & Diagram

1. Disconnect power to the outlet box before

installation.

2. Near the socket (D), locate and remove the two

flat-head screws (E) to release fixture from the
crossbar strap (A). CAUTION: DO NOT REMOVE THE
TWO HEX SCREWS (C).

3. Mount the crossbar strap (A) to the outlet box

leaving the screws on the crossbar strap facing
downward.

4. Connect the wires from the fixture (B) with the wires

in the outlet box according to generally accepted
electrical standards.

5. Slip the fixture (B) onto the crossbar strap (A) and

tighten the two flat-head screws (E) to secure the
fixture to the outlet box.

6. Install the bulb (F), by pushing it straight into the

socket (D).

7. Install the glass (G) by screwing it clockwise onto

the socket (D). Tighten hand-tight, do not over-
tighten.

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter fixture.