Holtkoetter 6444 User Manual

Bernie series table lamp no. 6444, Assembly instructions for

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: (800) 899-5444 • Fax: (888) 552-8661

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Bernie Series Table Lamp

No. 6444

This low-voltage halogen table lamp comes fully assembled.

Glass Shield and Bulb Replacement Instructions

1. Be sure to turn the lamp off and allow it to cool before attempting glass shield and/

or bulb replacement.

2. The glass shield (A) is held in place with an aluminum spring clip (B). To remove this

clip, hold each side and pull firmly from the socket. This will release the glass shield.
(Skip to Step 5 unless replacing bulb).

3. To remove the old bulb (C), pull it straight out of the socket. For a replacement bulb,

use only Osram Halostar IRC, max. 50 W. (Order Code: 9250*050-HSTAR.)

4. Install the new bulb, being careful not to touch the bulb envelope

with your bare hands. Hold the bulb at the porcelain grip and push it

straight into the socket.

5. Press the aluminum clip over the shield and onto the socket, making sure that both

sides snap into place.

UL requires the following safety instructions:

Lighted lamp is HOT! WARNING: Improper use of this fixture may increase the risk of FIRE,
ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE RADIATION or INJURY TO PERSONS.

IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:
1. Before replacing bulb, UNPLUG lamp and allow bulb to cool.
2. DO NOT touch hot glass shield or operate lamp with a missing glass shield.
3. Keep lamp away from materials that may burn.
4. Do not remain in light if skin feels warm or look directly at a lighted bulb.
5. Use of the Osram bulb provided with this lamp prevents exposure to excessive UV Radiation.

Use of any other bulb may cause a risk of exposure to excessive UV Radiation. Use of any
other bulb may also cause a risk of overheating or may rupture the bulb.

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to
spot clean. Do not use common household cleaners on lamps or fixtures, as the lacquer
on the outside of the brass may be damaged as a result.

(B)

(A)

(C)

Diagram