Holtkoetter 5907 - Manual

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN. Holtkötter ® and Holtkötter Leuchten ® are registered trademarks
of Holtkötter International, Inc. All Rights Reserved.
© Holtkötter International, Inc.
HOLTKÖTTER INTERNATIONAL, INC.
155 Hardman Avenue South, South St. Paul, MN 55075
fax: (888) 552-8661 • phone: (800) 899-5444
ASSEMBLY INSTRUCTIONS FOR
www.holtkoetter.com
e-mail: [email protected]
Please make sure that the following parts for your low-voltage pendant are enclosed:
Fixture including ceiling canopy, frame and height adjustment bar. 1.
This fixture utilizes an electronic, line-voltage (120 V input) to low-voltage (12 V
output) transformer by LIGHTECH. If you are planning to use a dimmer with this
fixture, we recommend using a Lutron ELV (electronic low voltage) style dimmer.
Fixture No. 5907/7 includes a 175-Watt transformer, allowing for a 20-Watt
maximum per bulb. NOTE: The electronic transformer by LIGHTECH is equipped
with an automatic reset switch. If the fixture is not working or has created a
short, disconnect the power to the fixture and the transformer will reset itself.
Additional backplate and universal crossbar strap
2.
Acrylic Reflector 3.
Bulbs for 5907/7: 7 ea x 20 Watt Halostar by Osram, G4 base. 4.
Order Code: 9250*020-HSTAR-G4
Be sure to turn off the circuit breaker before installing this fixture.
It is recommended that this fixture be installed and hung by a licensed electrician.
UL SAFETY REQUIREMENTS
Underwriter’s Laboratories requires that these IMPORTANT SAFETY INSTRUCTIONS be listed:
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
LIGHTED LAMP IS HOT!
WARNING: TO REDUCE THE RISK OF FIRE OR INJURY, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:
Turn off power and allow to cool before replacing lamps. 1.
Lamp gets HOT quickly! Contact only switch/plug when turning on. 2.
Keep lamp away from materials that may burn. 3.
Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp. 4.
Do not operate luminaire with missing or damaged glass. 5.
CAUTION: The recommended replacement bulbs for this fixture are 20 Watt Halostar-G4 bulbs by
Osram. Use of other brands of unknown quality may cause a risk of overheating.
Low-voltage Halogen Pendants
No. 5907/7
Care Instructions
Use only a soft, dry cloth to clean the finished parts. If necessary, a slightly damp, soft cloth can be
used to spot clean the finished parts. Use a soft, damp, lint-free cloth to clean the acrylic parts.
Do not use common household cleaners on lamps or fixtures, as the lacquer on the outside of the
brass may be damaged as a result. Enjoy your new Holtkötter lamp.
5907/7