Low-voltage halogen pendant no. 5515, Assembly instructions for – Holtkoetter 5515 User Manual

Page 2

www.holtkoetter.com

ASSEMBLY INSTRUCTIONS FOR

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

Holtkötter

and Holtkötter Leuchten

© Holtkötter

Please make sure that the following parts for
your low-voltage pendant are enclosed:

1. Fixture including ceiling canopy, frame and height

adjustment bar.

2. Additional backplate and universal crossbar strap

3. Glass shades

4. Bulbs: 5 each x 20 Watt Halostar by Osram, GY6.35

base. Order Code: 9250*020-HSTAR

This fixture utilizes an electronic, line-voltage (120 V input)
to low-voltage (12 V output) transformer by LIGHTECH
rated at 175 Watts, allowing for a 20-Watt maximum per
bulb.

If you are planning to use a dimmer with this fixture, we recommend using a Lutron ELV
(electronic low voltage) style dimmer.

NOTE: The electronic transformer by LIGHTECH is equipped with an automatic reset switch. If
the fixture is not working or has created a short, disconnect the power to the fixture and the
transformer will reset itself.

Be sure to turn off the circuit breaker before installing this fixture.
Dry location only.

THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR
WITH CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED.

Mounting Instructions (Diagram 1)

Parts used:
A) Round 5” decorative plate with universal crossbar

B) Long metal strap with screws

C) Two brass tubular nuts

D) Two decorative knobs.

Low-voltage Halogen Pendant

No. 5515

Mounting Instructions, continued

1. Disconnect power to the box before installation.

2. Remove decorative knobs (D) and the brass tubular nuts (C) that are located under

the decorative knobs (D).

3. Remove the long metal strap (B) located on the top of canopy.

4. Mount the round decorative plate (A) to the metal strap with screws provided on the

universal crossbar strap, then mount the assembled piece to the outlet box.

5. Connect the wires from the fixture with the wires in the outlet box according to

generally accepted electrical standards. Determine
the polarity of the cord by rubbing it with your thumb.
One side will feel smooth (= hot/black) and the other
side will feel rough (= cold/white).

6. Slide the canopy over the metal strap and secure

with brass tubular screws (C).

7. Finally put decorative knobs (D) on the bottom of the

canopy.

Fixture Cable Length Adjustment (Diagram 2)

This low-voltage pendant cannot be lengthened in the
field. Due to the nature of this support system, fixtures
requiring longer support cables will have to be special
ordered.

1. To shorten the overall support cable lengths, begin

by pulling the cable cover (E) straight up to reveal
the cable guide (F).

2. Take the weight off the fixture and pull enough cable

through the guide to correct the height.

3. Cut the excess cable off, push the cable and cable

cover back into place.

Fixture Height Adjustment (Diagram 3)

The center bar (G) between the canopy and the fixture can be
raised or lowered to adjust the overall height of the fixture.

Press the knobs (H) at each end of the center bar simultaneously
to raise or lower the fixture to the desired height.

Diagram 2

Diagram 3

Diagram 2

Diagram 1

Diagram 3