Holtkoetter 5515 User Manual
Low-voltage halogen pendant no. 5515, Assembly instructions for
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: [email protected]
www.holtkoetter.com
ASSEMBLY INSTRUCTIONS FOR
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter
®
and Holtkötter Leuchten
®
are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Low-voltage Halogen Pendant
No. 5515
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.
5515/5
CSA/UL SAFETY REQUIREMENTS
CSA/UL requires that these IMPORTANT SAFETY INSTRUCTIONS be listed:
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
LIGHTED LAMP IS HOT!
WARNING: TO REDUCE THE RISK OF FIRE OR INJURY, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:
1. Turn off power and allow to cool before replacing lamps.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Keep lamp away from materials that may burn.
4. Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
5. Do not operate luminaire with missing or damaged glass.
6. CAUTION: The recommended replacement bulbs for this fixture are 20 Watt Halostar
bulbs by Osram. Use of other brands of unknown quality may cause a risk of
overheating.
J
K
J
L
Diagram 4
Install the Bulbs & Glass (Diagram 4)
1. The bulbs provided with this fixture are specialty low-voltage
bulbs by Osram, the Halostar Starlite. Insert the bulbs (J) into
the sockets. NOTE: BE CAREFUL NOT TO TOUCH THE BULB
WITH YOUR BARE HANDS.
CAUTION: Always remember to disconnect power to the
fixture before replacing bulbs to prevent damage to the
bulbs.
2. Using the plastic socket driver (L) provided, screw each glass
shade (K) onto the fixture until it is snug. Do not overtighten.