Kenwood TK-2185E - Manual (Page 31)

2
h
ome
A
ddreSS
If a key has been programmed with the Home Address
function, you can press that key to jump to the
pre-programmed call address.
• “HAD” appears in the sub-display when the selected call address is
the Home Address.
Press Home Address a second time to return to the previous
call address you were using.
S
ite
l
ock
Press and hold this key for second to lock the Site. “SITE
LOCKED” momentarily appears on the display. Press and hold
this key again for second to cancel Site Lock.
S
uB
-lcd d
iSplAy
If a key has been programmed with the Sub-LCD Display
function, you can press that key to jump to the toggle the
sub-display between “SVC”, the current control channel
number, and the signal strength readout.
S
witching to
c
onventionAl
m
ode
Depending on how your transceiver is programmed, you can
enter Conventional Mode in one of two ways:
Manual: When in Trunking Mode, press the key programmed
as Conventional to change the operating mode. This function
only works when no signals are currently being received.
Auto: The transceiver automatically changes to Conventional
Mode when you are outside the network area.
v
iBrAtor
Press and hold this key for second to toggle the vibrator function
ON and OFF. When the vibrator is on, the transceiver will vibrate
when a voice call (Individual/GroupPSTN/PABX) is received and
when a status message, SDM, or NPD is in the stack.
• When the Vibrator function is activated, the Vibrator indicator
( ) appears on the display.