Kenwood TK-2185E - Manual (Page 26)

6
S
tAtuS
c
AllS
■
Making a Status Call
1 Rotate the selector or press the keys programmed as
Call Address Up and Call Address Down to select
your desired call address.
2 Press the Status/ Stack key (default: S key), then rotate
the selector to select your desired status.
• The status number appears on the sub-display.
3 Press the Call key (or PTT switch if “PTT to Initiate Call”
has been programmed) to send the status.
• “CALLING” appears on the display.
4 When the status has been received by the called party,
“COMPLETE” momentarily appears on the display
before returning to the previously selected call address.
■
Receiving a Status/Short Data Message Call
1 When a call is received, the icon appears on the
display and flashes.
• The icon remains on the display when there is data in the
stack.
2 To view the status or message, refer to “V
iewing the
S
tack
”,
on page 8.
d
AtA
c
AllS
■
Making a Data Call
1 Enter control code 2 to make a SDM (Short Data
Message) call.
2 Press the key, then enter your message.
• Enter characters using the keypad or by rotating the
selector. When rotating the selector, press the or C>
key to set the selected character.
• To clear a character, press the Clear key. To clear all
entered characters, press and hold the Clear key.