Kenwood K-323-BK - Manual (Page 45)

45
English
CD Section
Symptom Remedy See page
Loaded CD cannot be played back.
Place the CD properly with the label side up.
Clean the disc.
Wait until the condensation on the disc surface evaporates.
•
•
•
17
42
42
CD audio is not output.
Press [CD E].
Clean the disc.
•
•
17
42
CD sound skips.
Playback is impossible if the audio file is destroyed.
Check if the audio file is playable with this system.
•
•
40
An audio file cannot be played.
Playback is impossible if the audio file is destroyed.
Check if the audio file is playable with this system.
•
•
40
Playback takes time before starting.
The time until playback may become long if there are large
number of folders and/or files.
•
—
The tag information is displayed improperly. Confirm the tag information that can be displayed on this unit. • 40
Component connected to D.AUDIO IN connector
Symptom Remedy See page
Kenwood digital audio player cannot
be controlled from the main unit or
remote control unit.
Connect it using the special connection cable (optional).
Check if a compatible model is connected.
•
•
10
42
Remote Control Unit
Symptom Remedy See page
Remote control is unavailable.
Replace the batteries with new ones.
Use the remote control unit within the controllable distance.
•
•
7
15
Resetting the system
Symptom Check Points & Remedy
The system malfunctions (resulting
in inoperability of the system,
erroneous display, etc.).
The system may malfunction due to unplugged and plugging of a cable while
the system is ON or to an extraneous cause. In this case, reset the system with the
following steps. Resetting the microcomputer results in erasing the setups of the
system and returns it to the factory shipped condition.
1 Unplug the power plug from the mains outlet.
2 While pressing and holding [K] on the main unit, unplug the power cord and
plug it again.
"INITIALIZE" is displayed.
This unit is reset.
Main
tenanc
e