Kenwood K-323-BK - Manual (Page 44)

K-323
44
A trouble with the system does not always mean the failure. Before calling for service, check the following table
according to the symptom of trouble.
Amplifi er/Speaker Section
Symptom Remedy See page
No sound output.
Reconnect the cords properly.
Increase the volume level.
Cancel muting.
If headphones are plugged in, unplug them.
•
•
•
•
9~11
16
16
11
The [STANDBY/TIMER] flashes red
and no sound is output.
An internal fault may be produced. Turn the system OFF, unplug
the power cord and call for service.
•
—
No sound from headphones.
Check if headphone plug is inserted properly.
Increase the volume level.
Cancel muting.
•
•
•
11
16
16
The time of the day is not displayed. Set the time of the day. • 32
Timer cannot be activated.
Set the time of the day ([STANDBY/TIMER] indicator is flashing
in orange).
Set the On time and Off timer of program timer.
•
•
32
34
Tuner Section
Symptom Remedy See page
Radio stations cannot be tuned.
Connect the antenna(s).
Select the correct tuning band (tuning mode).
Tune into the frequency of the desired station.
•
•
•
9
26
26
Noise interferes with reception.
Install the outdoor antenna away from the road.
Turn OFF the electric appliances installed near this system.
Install the system away from a TV set.
•
•
•
—
Preset stations cannot be called.
Preset radio stations with AUTO MEMORY again.
Preset stations with receivable frequencies manually.
•
•
27
28
USB Section
Symptom Remedy See page
Sound is not output even when
a USB flash memory or USB mass
storage class compatible audio
player is connected.
Insert the USB flash memory properly.
Connect the USB cable properly.
Check if the USB mass storage class compatible digital audio
player is turned ON.
•
•
•
10
Troubleshooting