Kenwood K-323-BK - Manual (Page 43)

43
English
Main
tenanc
e
Handling of iPod
Handling precautions
Be sure to read the instruction manuals provided with
your iPod.
The iPod is not provided with this system.
The saved data may be lost depending on the operating
situations of the iPod. Kenwood will not assume any
liabilities for the damage incurred due to loss of saved data.
Usable iPod
To control an iPod from the main unit or remote control
unit, the PAD-iP7 iPod Dock is necessary.
For the usable iPod models, refer to the manual for the
PAD-iP7.
Handling of USB device
Handling precautions
Be sure to read the instruction manuals provided with
each USB device.
The USB device is not provided with this system.
The [USB] connector on the rear of this unit is USB2.0 (Full
speed) compatible.
It is not permitted to connect a USB device through a USB
hub.
The data saved in the USB device may be lost depending
on the usage conditions. Kenwood will not assume any
liabilities for the damage incurred due to loss of saved data.
Usable USB devices
The following restrictions are applicable to the type and
operating method of the USB device.
The USB device should be USB mass storage class
compatible. For whether each USB device is compatible
with the USB mass storage class, consult its dealer.
The maximum current drain should be no more than "500
mA".
If a USB device other than specifi ed above is used, the
music fi les may be unable to be played correctly. Also,
note that even a USB device complying with the above
specifi cations may be unable to play certain music fi les
depending on the type or condition of the music fi les.
•
•
•
•
•
•
•
•
•
•
•
Caution for Transport or Movement
Before transporting or moving the system, prepare it as
described below.
1 Disconnect the external components including the
USB device, and also take out the disc.
2 Press [CDE] and confi rm that "NO DISC" is
displayed.
3 Wait a while, and then turn the system OFF.
4 If any other external component is connected, make
sure that it is turned OFF before disconnecting the
connection cable.
Memory Backup
Even when the power plug is unplugged from the mains
outlet, the setups of the unit are retained for about a day.
The backed up setups are as follows.
Sound and system setups
Input source selection
Volume setting
Input level setting
D-BASS and TONE settings
TIMER SET setting
DIMMER setting
DISP. SAVER setting
A.P.S. setting
Rec Out LEVEL setting
Tuner setups
Preset stations
Tuning mode
(Auto/manual tuning)
Receiving band
Receiving frequency
•
•
•
•
•
•
•
•
•
•
•
•
•