Controlling general audio, P.143) – Kenwood DNN991HD User Manual
Page 144
143
Ñ
DSP select
You can select whether using DSP (Digital
Signal Processor) System.
1
Touch [Bypass] or [Through] of [DSP
Select] in the Audio SETUP screen.
Bypass
There is no effect by DSP.
Through
There is an effect by DSP.
NOTE
• When the mode is set to [Bypass], DSP System
cannot be adjusted.
Controlling General Audio
1
Touch [
] on any screen.
2
Touch [Audio].
Audio screen appears.
3
Touch [Audio Control].
4
Set each item as follows.
Fader # / Balance #
Adjust the volume balance around the
touched area.
[
C] and [D] adjust the right and left volume
balance.
[
R] and [S] adjust the front and rear volume
balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
Subwoofer Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
Bass Boost
Set the amount of bass boost among “OFF”/
“Level1”/ “Level2”/ “Level3”.
* If you have increased the volume first, then
reduced the volume using the “Volume
Offset”, the sound generated if you
suddenly switch to another source may be
extremely loud.