Dsp settings – Kenwood KDC-U7056BT User Manual
Page 9
18
|
KDC-U7056DAB/ KDC-U7056BT/ KDC-U7056BTL
English
|
19
DSP settings
4-10. DSP preset
You can register the values set the DSP control
items.
1
Set the DSP control items
Refer to the following operations to setup the
Sound Control.
- “SubWoofer Level” of
<4-1. Audio control> (page
12)
-
<4-2. Manual equalizer control> (page 13)
-
<4-3. Car type selection> (page 13)
-
<4-4. Speaker setting> (page 14)
-
<4-5. X’Over setting> (page 15)
-
<4-6. Listening position setting> (page 16)
-
<4-7. Delay time control> (page 16)
-
<4-8. Channel level fine adjustments> (page
17)
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Audio Control”
>
“Pro Setup”
>
“Audio
Preset”
>
“Memory” using [Control] knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 9)
.
4
Select a memory number (“Memory 1” or
“Memory 2”) using [Control] knob.
5
Select “YES” using [Control] knob.
“Memory Completed” appears.
Exiting from the Function setting mode
Press and hold [
1/6].
When reset
• When this unit is reset, all setting values stored in “Memory
1” are applied to the source.
4-11. DSP preset recall
You can recall the DSP control items registered to
the
<4-10. DSP preset> (page 18)
.
1
Press [SRC] to select a recall source.
Refer to
.
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Audio Control”
>
“Pro Setup”
>
“Audio
Preset”
>
“Recall” using [Control] knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 9)
.
4
Select a recall memory number (“Recall 1” or
“Recall 2”) using [Control] knob.
5
Select “YES” using [Control] knob.
“Recall Completed” appears.
Exiting from the Function setting mode
Press and hold [
1/6].
4-9. Resetting of DTA Settings
You can reset the DTA-compensated values to the
factory settings.
1
Press [SRC] to select a source other than
Standby (“STANDBY”).
Refer to
.
2
Press [Control] knob.
Enters the Function setting mode.
3
Select “Audio Control”
>
“Pro Setup”
>
“DTA
Settings”
>
“Reset DTA Setting” using [Control]
knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 9)
.
4
Select “YES” using [Control] knob.
Exiting from the Function setting mode
Press and hold [
1/6].