Kenwood KDC-U7056BT - Manual (Page 21)

42 | KDC-U7056DAB/ KDC-U7056BT/ KDC-U7056BTL English | 43
Listen to the tuner
9-5. Tuner setting
You can set up the tuner.
1 Press [SRC] to select a Tuner (“TUNER”) source.
Refer to
(page 10) .
2 Press [Control] knob.
Enters the Function setting mode.
3 Select “Settings” using [Control] knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 9) .
4 Select a Tuner setting item using [Control]
knob
Display Description
“Local
Seek” [1]
Only stations whose reception is good are searched in
auto seek tuning. (FM only)
“ON” / “ OFF ”
“Seek Mode” Sets the seek mode.
“ Auto1 ”: Automatic search for a station.
“Auto2”: Search in order of the stations in the preset
memory.
“Manual”: Normal manual tuning.
“MONO” You can reduce the noise when stereo broadcasts are
received as monaural.
“ON” / “ OFF ”
“TI” [1] Switches to the traffic information automatically when
the traffic bulletin starts.
“ON” / “ OFF ”
“News
Interrupt” [1]
Automatically receives news bulletin when it starts. Set
the time during which interrupt is to be disabled after
start of another news bulletin.
Changing “00MIN” to “90MIN” turns this function ON.
If news bulletin starts when this function is ON, “NEWS”
appears and news is received. If “20MIN” is has been
set, reception of another news bulletin will not start
for 20 minutes.
The news bulletin volume is the same level that was set
for Traffic Information.
“ OFF ” / “00MIN” – “90MIN”
“AF” [1] When the reception is poor, automatically alternate
to another frequency broadcasting the same program
in the same Radio data system network with better
reception.
“ ON ” / “OFF”
“Regional” [1] Sets whether to switch to the station only in the
specific region using the “AF” control.
“ ON ” / “OFF”
“Auto TP Seek”
[1]
When traffic information station reception is poor,
automatically searches for a station that can be received
better.
“ ON ” / “OFF”
( Colored text : Factory setting)
[1] Function of KDC-U7056DAB.
5 Select a setting using [Control] knob.
Returns to the previous item.
9-6. Direct access tuning
(Function of remote control)
You can search for a station directly by entering
frequency.
1 Press [DIRECT] on the remote control.
“– – – –” appears and enter the Direct access tuning
mode.
2 Press the number buttons on the remote
control to enter the frequency.
Example:
Desired frequency Press the following buttons
92.1 MHz (FM) [9], [2], [1]
810 kHz (AM) [8], [1], [0]
3 Press [ENT] on the remote control.
Exiting Direct access tuning mode
Press [ 6] on the remote control.
Exiting from the Function setting mode
Press and hold [ 1/6].