Agilent Technologies 34401A - Manual (Page 39)

Menu Example 2 The following exercise demonstrates how to use the menu recall feature
as a shortcut to set the
BEEP command back to its original setting.
You must perform the steps in Example 1 before you start this example.
1 Use menu recall to return to the BEEP command.
This returns you to the BEEP command, which was the last command
used before you exited the menu in the Example 1.
6: BEEP
2 Move down to the BEEP parameter choices.
The first parameter choice is “ OFF ” (the current setting from Example 1).
OFF
3 Move across to the “ON” choice.
Set the parameter back to its original value.
ON
4 Save the change and turn off the menu.
The multimeter beeps and displays a message to show that the change
is now in effect. You are then exited from the menu.
CHANGE SAVED
Shift >
>
Recall
∨
Auto/Man
ENTER
2
Chapter 2 Front-Panel Menu Operation
A Front-Panel Menu Tutorial
33