Summers Superchisel - 5-Section - Manual (Page 58)

DAILY MAINTENANCE
1. Grease lift arms, walking tandem assemblies, wing pivots, and hitch pivots.
2. Check all hydraulic components for leaks.
3. Check the tightness of all wheel bolts.
PERIODIC MAINTENANCE
1. Repack wheel bearings and check their tightness (See Page 6-10).
2. Check tire air pressure (See specification page 5-2).
3. Check tightness of trip assembly hardware as explained under “Maintenance for after
the first day and week of operation”.
4. Check the tightness of all hardware. Pay special attention to the hitch bolts and all pivot
retaining bolts.
5. Check chisel plow for damaged or worn parts. Replace as needed.
STORAGE
1. Clean and remove all excessive dirt and grease from the chisel plow.
2. Grease all zerks.
3. To prevent rusting, repaint any areas that have been worn, chipped or scratched.
4. Retract cylinders when possible. Apply grease* to any exposed part of cylinder shafts.
4-2
SECTION 4 – MAINTENANCE
*NOTE: Before returning chisel plow into service, all grease must be removed from cylinder
shafts to prevent damage to seals.