Summers Superchisel - 5-Section - Manual (Page 41)

2-29
SECTION 2 – CONNECTING AND SEQUENCING WING LIFT
3. Connect rod end of 4-1/2 x 16” cylinders to part 2 wing.
– Install one 8T3608 pin with 5/16” roll pin and 1-1/2” FW into an 8T3590 link and insert it into
the collar on the part 1 wing. Install another 8T3590 link onto the other side of pin and secure
with 1-1/2” FW (as required to remove clearance, must be free to pivot) and 5/16” roll pin.
– Install an 8T3608 pin with 5/16” roll pin and 1-1/2” FW into the opposite end of the 8T3590 link.
Slide an 8T2514 spacer onto pin. Slide pin through one side of cylinder clevis and through
8T0400 lift link. Continue to push pin through clevis, another spacer and top of other 8T3590
link. Secure pin with FW (as required) and roll pin.
– With the 8T0400 link resting between the two flame cuts with slots, install an 8T3625 pin into
an 8T2530 and 8T2520 roller and slide pin through slot and into bottom of the lift link (8T0400).
Apply anti-seize to 8T3625 prior to installation.
– Repeat sequence on other side of slot. Secure pin with 1-1/2” FW (as required) retaining collar
(7T2532), 7/16 x 3” bolt and locknut.
– Repeat these steps for all 4 part 2 wing lift cylinders.