Part 1 wing set-up, Set-up of part 1 wing -8 – 2-11 – Summers Superchisel - 5-Section User Manual

Page 20

2-8

SECTION 2 – SET-UP PART 1 WING

NOTE: It is recommended to set up both sides of machine at the same time. The left hand side will

be the only one shown.

1. Attach wing to center section with pins, washers, bolts and locknuts.

– Washers are used to center wing in hinges and prevent shift.

2. Fasten cylinder attach brackets (8T4226) with 3/4” u-bolts.

– Bracket should be located 188” on 50’-54’, 212” on 56’-60’ from the center of the machine.

3. Insert eyebolts (8K1683) into cylinder attach bracket.

– Tighten 1-1/2” nuts so the same amount of threads are above the top nut on all eyebolts. Insure

that cylinder attach holes are aligned when eyebolts are tightened.