Summers Superchisel - 5-Section - Manual (Page 13)

SECTION 2 – ASSEMBLY INTRODUCTION
GENERAL ASSEMBLY INSTRUCTIONS
1. READ AND UNDERSTAND Operator’s Manual before assembly of machine.
2. Machine should be assembled in horizontal (field) position only.
3. If machine is to be assembled INDOORS, check that exit door is a MINIMUM OF 19’6”
WIDE. Minimum height requirement is
Machine Width Height
28-44’ 10’8” - 18’0”
50-54’ 15’8”
56’-60’ 17’8”
Shanks may be left off to reduce height and width requirement.
4. Reference to “RIGHT” and “LEFT” is determined when machine IS VIEWED FROM
THE REAR.
5. Reference to “FORWARD” means TOWARDS THE TRACTOR.
6. Reference to “REAR” means AWAY FROM THE TRACTOR.
SAFETY-ALERT SYMBOL
This symbol is an alert to the potential
for personal injury. This symbol means
ATTENTION! BECOME ALERT!
YOUR PERSONAL SAFETY IS INVOLVED!
2-1