Red Lion IAMS - Manual (Page 3)

2
WArnIng!
The IAMS devices are designed for connection to hazardous
electric voltages.
Ignoring this warning can result in severe personal injury or
mechanical damage.
To avoid the risk of electric shock and fire, the safety instruc­
tions of this manual must be observed and the guidelines
fol lowed. The specifications must not be exceeded, and the
devices must only be applied as described in the following.
Prior to the commissioning of the devices, this manual must be
examined carefully.
Only qualified personnel (technicians) should install these
devices. If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the equipment
may be impaired.
WArnIng
To keep the safety distances, the relay contacts on the devices
must not be connected to both hazardous and non­hazard ous
volt ages at the same time.
The IAMS devices must be mounted on a DIN rail according to
DIN 46277.
WArnIng!
Until the devices are fixed, do not connect hazardous voltages
to the devices.
The following operations should only be carried out on
disconnected devices and under ESD safe conditions:
General mounting, connection and disconnection of wires.
Troubleshooting the devices.
repair of the devices and replacement of circuit breakers
must be done by red Lion Controls only.
HAZArD­
oUS
VoLtAge
InStAL­
LAtIon
generAL
WArnIng
Do not open the front plate of the devices as this will cause
damage to the connector for the display / programming module
PGMMOD00. The devices contain no DIP­switches or jumpers.