HighPoint RocketRAID 2210 - Manual (Page 8)

Introduction
Understanding RAID Concepts and Terminology
The following concepts and terminology is commonly used when describing the
functions of the RocketRAID 2210 Host Adapter.
Disk initialization
Initializing a disk writes necessary RAID configuration information to that disk. Disks
must be initialized before configuring them into RAID arrays. The initialization
process will destroy all data on the disk.
Disk Status
New The disk contains no data and has not been initialized.
Initialized The disk has been initialized and can be used for array creation.
Configured The disk has been assigned to one or more arrays, or configured as a
spare disk.
Legacy The disk was used on other controllers before use with the
RocketRAID 2210 (see legacy disk below).
Array initialization
A redundant array (RAID 5, RAID 1, RAID 10) needs to be initialized to ensure full
performance and reliability. Non-redundant arrays (RAID 0, JBOD) do not need to be
initialized.
When you create a redundant array using the RocketRAID 2210 controller’s BIOS
Configuration Utility, it will create the array in un-initialized state. The initialization
process can be completed after installing the driver and management software.
When creating an array using the HighPoint RAID Management Console software,
you can specify an initialization option (Skip initialization, foreground and
background).
1-2