HighPoint RocketRAID 2210 User Manual
Page 43
RocketRAID 2210 Driver and Software Installation
4
10 - Configuring Remote Systems
Then HighPoint RAID Management Console manages a RAID controller through a
connection to the HighPoint RAID Management Service, which runs on the system
where the RAID host adapter is physically installed. This type of system is referred
to as a “remote system”.
Note: What the software classifies as a “remote system” may not always be an actual
remote computer. In some configurations, the local computer hosts both the RAID
host adapter and Management Service. The local system, in these cases, is still
generically referred to as a “remote system”.
Add a Connection
This command is used to add new connection to a remote system. To Add a
Connection:
1.
Highlight the “File” menu, and select the “Remote Control” function.
2.
Click the Add button on the toolbar or select the “Add” command from the
“Operation” menu.
3.
Enter the system address, name, and port information in the popup window.
The system address can be a host name, or an IP address. The default system port is
7402.
4.
Click “OK” to finish adding the new connection.
4-18