Vaisala DMT152 - Manual (Page 56)

User's Guide _______________________________________________________________________
54 ___________________________________________________________________ M210865EN-F
Example:
time 12 30 00
12:30:00
time
12:30:05
Reset Transmitter
When the RESET command is given, the transmitter will restart as if it
had just been powered on. All transmitter settings are retained. The serial
line mode of the transmitter will be set to the mode that was set using the
SMODE command.
As the transmitter starts up, it performs the startup sensor purge and auto-
calibration before resuming measurement.
RESET
Set LED Voltage
With the LED command, you can set the supply voltage that is provided
to the LED when the LED alarm mode is used. If you are using the
Vaisala LED cable, leave this setting at the default voltage (2.80 V).
LED
Example:
led
Ch 1 Led Voltage : 2.80 V
Ch 2 Led Voltage : 2.80 V
Restore Factory Settings
Use the FRESTORE command to restore the factory settings to the
transmitter. All user settings will be lost.
FRESTORE