beautypg.com

Adjusting alarm volume, Keepsafe, Deluxe 11 – Posey KeepSafe® Deluxe User Manual

Page 11

background image

KeepSafe

®

Deluxe

11

Adjusting Alarm Volume

There are two (2) alarm volume settings: low and high. These allow you to select the right volume for

facility and/or patient needs.
All volume settings are within oSHA standards. For maximum staff alert in noisy areas, use HIGHEST

(loudest) volume setting.

alWayS check to ensure staff can hear alarm at the furthest possible distance before

leaving patient unattended.

NEVER place alarm closer than two feet from patient’s ear. Doing so may cause hearing

loss or other injury. For more information, see: OSha OCCuPaTiONal NOiSE EXPOSuRE STaNDaRDS

1910.95.

To Change Volume:

1. Ensure alarm is on and either sensor pad, chair belt sensor or PIR

sensor is attached to alarm. Ensure pressure is on sensor pad, chair belt

sensor is connected, or PIR sensor is connected.

2. Remove the battery compartment door by sliding down to gain access

to the programming buttons.

3. Press VolUME button (fig. 6) to scroll through both the volume

selections.

4. Alarm mode must be set to either “Voice and Tone” or “Tone” (see

page 9) in order to hear the selection.

5. Each time you press the button, the volume changes and a two (2)

second sample plays.

6. Continue to press the VolUME button until you hear the desired volume. The last sample heard is the

volume in use.

7. Replace the battery door and slide shut, locking into place.
NOTE: Cat. 8374NP does not have an oN/oFF switch. To set Alarm Volume for Cat. 8374NP, follow all

steps above except step 1.

Fig. 6

Tone

Volume

Voice

&

Tone

Voice

Tone

Qt

y

4A

AA

A

lk

ali

ne

AN

SI-

24

A I

EC

-L

R0

3