Posey KeepSafe® Deluxe - Manual (Page 10)

10 KeepSafe ® Deluxe
Setting Alarm Tone
The KeepSafe Deluxe has five (5) available tones. This allows you to differentiate between patients and
other equipment alarms.
To Select Tone:
1. Ensure alarm is on and either sensor pad, chair belt sensor or PIR sensor
is attached to alarm. Ensure pressure is on sensor pad, chair belt sensor
is connected, or PIR sensor is connected.
2. Remove the battery compartment door by sliding down to gain access
to the programming buttons.
3. Press ToNE button (fig. 5) to scroll through the tone selections.
4. Alarm mode must be set to either “Voice and Tone” or “Tone” (see page
9) in order to hear the selection.
5. Each time you press the button, tone will change and a two (2) second
sample plays. The last sample heard is the tone utilized for the alarm
when the sensor is activated, depending on which monitoring mode is
selected.
6. Replace the battery door and slide shut, locking into place.
NOTE: Cat. 8374NP does not have an oN/oFF switch. To set Alarm Tone for Cat. 8374NP, follow all steps
above except step 1.
Tone Volume
Voice
&
Tone
Voice Tone
Qt
y
4A
AA
A
lk
ali
ne
AN
SI-
24
A I
EC
-L
R0
3
ty
4
AAA
Fig. 5