APC iSCSI SATA II User Manual
Page 67
[67]
3.8.2 Upgrade
“Upgrade” can upgrade firmware. Please prepare new firmware file named
“xxxx.bin” in local hard drive, then click “
” to select the file. Click
“
”, it will pop up a message “Upgrade system now? If you want
to downgrade to the previous FW later (not recommended), please export your system
configuration first!”. Click “Cancel” to export system configuration in advance, or
click “OK” to start to upgrade firmware.
When upgrading, there is a progress bar running. After finished upgrading, the system
must reboot manually to make the new firmware take effect.
3.8.3 Reset to Default
Enter “Reset to default” function, it allows user to reset the controller to the factory
default setting.
Reset to default value, the password is: 00000000, and IP address to default DHCP.
Default IP address: 192.168.10.50 (DHCP)
Default subnet mask: 255.255.255.0
Default gateway: 192.168.10.254