APC iSCSI SATA II - Manual (Page 19)

[19]
2.4 Connecting the iSCSI RAID Subsystem to Your Network
To connect the iSCSI unit to the network, insert the cable that came with the unit
into the Gigabit network port (LAN1) on the back of iSCSI unit. Insert the other
end into a Gigabit BASE-T Ethernet connection on your network hub or switch. You
may connect the other network port LAN2 if needed.
For remote management of the iSCSI RAID subsystem, connect the R-Link port to
your network.
2.5 Powering On
1. Plug in the power cord into the AC Power Input Socket located at the rear of
the subsystem.
2. Turn on the Power Switch.
3. The Power LED on the front Panel will turn green.