AMX Distribution Matrix Octaire - Manual (Page 38)

Installation and Setup
34 Octaire Instruction Manual
Secondary Enclosure(s)
Set the TTL switch to “on” (be sure the BB switch is “off”).
Important: The INV (Inverted) toggle switch must be set to “off” at all times.
To set the VIS toggle switches:
1. Using a small screwdriver or paper clip, toggle each video enclosure’s DIP switch according to the
information provided on the previous page.
Important: After the VIS toggle switches are set, the system must be enabled from the control panel
to handle VIS switching.
2. Enable the system for the VIS switching according to the directions in the “Setup Options” section
on page 59.