Outback Power Systems GVFX Series Inverter/Charger Installation Manual - Manual (Page 75)

73
INSTALLATION CHECK LIST
ITEM YES NO
All manuals read and reviewed?
FX
OutBack Charge Controller
MATE
HUB
System mounted with the recommended number and sized fasteners?
System installed according to local codes?
System inspected?
System permanently grounded?
Did the installer use OutBack recommended wire type and gauge adjusted for
temperature ratings and length?
All AC wiring rated for 75° C or higher?
Battery cables rated 75° C or higher?
6 AWG (0.184” or 4.11 mm) wire or larger used for FX AC Hot In and AC Hot Out?
FX connected to AC circuit with 60 amp branch-circuit overcurrent protection?
All cables torqued to OutBack specifications?
AC and PV breakers to 22 inch-lbs/2.48 Nm?
All DC connections to 10 foot-lbs/13.55 Nm?
FX AC terminals to 30 inch-lbs/3.38 Nm?
FX battery breaker to 45 inch-lbs/5.08 Nm?
All terminal block screws torqued to 2.5 foot-lbs/3.38 Nm?