GReddy e-Manage Ultimate Installation Manual - Manual (Page 22)

Device
Connect to
desired channel
Relay
Relay
•These channels can be used for relays to activate desired devices.
14. NVCS / Relay Channels
21
NVCS (Nissan Valve Control System)
•Connecting one of these channels to the NVCS solenoid to control the NVCS.
NVCS Solenoid
Cut and
tape up
Connect to
desired channel
ECU
(Engine Control Unit)
•Make sure the wire that was cut is taped up to prevent any short.
•When using this feature the proper channels must be configured in the “I/J” set up in the
Parameter setting in the software and make the necessary jumper setting to activate these
channels.
Connector B
Connector B
•When using this feature the proper channels must be configured in the “I/J” set up in the
Parameter setting in the software and make the necessary jumper setting to activate these
channels.