GReddy e-Manage Ultimate Installation Manual - Manual (Page 16)

• examples for ADD ONLY setup:
15
10. Injector Signal Wires
• Wire the injector signal wires for each cylinders. (except for Rotary Engines).
• Normally, the Injector Adjustment will be set to add & trim (jumper JP1~6, 18 set to “OPEN”.
Inj Adj. Map will be used to add and trim fuel). This can be set for add only. (jumper JP1~6, 18
set to “1-2”. Inj Adj. Map will be used to add fuel only)
• examples for ADD / TRIM setup:
ECU
(Engine Control Unit)
Female connector
Male connector
Splice
×
Light Blue/Red (I/J CH- 6 IN)
Pink/Red (I/J CH- 5 IN)
Purple/Red (I/J CH- 4 IN)
Black/Red (I/J Ground)
Purple/Grey (I/J CH- 4 OUT)
Ч Ч Ч Ч Ч
Light Blue/Grey (I/J CH- 6 OUT)
Pink/Grey (I/J CH- 5 OUT)
Blue/Grey (I/J CH- 1 OUT)
Orange/Grey (I/J CH- 2 OUT)
Yellow/Grey (I/J CH- 3 OUT)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
#E
Female connector
Male connector
Splice
×
Black/Red (I/J Ground)
Ч Ч
Blue/Grey (I/J CH- 1 OUT)
Orange/Grey (I/J CH- 2 OUT)
Yellow/Grey (I/J CH- 3 OUT)
• for 6 cylinder group injection • for 6 cylinder individual injection
#E
• for 6 cylinder group injection
#3 #1
#E #2
• for 6 cylinder individual injection
On a vehicles with low resistance injectors without dropping resistors (AE86, R31), change
the injectors to high resistance injectors or add a dropping resistors.
IMPORTANT
ECU
(Engine Control Unit)
Female connector
Male connector
Splice Female connector
Male connector
Splice
ECU
(Engine Control Unit)
ECU
(Engine Control Unit)
Light Blue/Red (I/J CH- 6 IN)
Pink/Red (I/J CH- 5 IN)
Purple/Red (I/J CH- 4 IN)
Black/Red (I/J Ground)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
Black/Red (I/J Ground)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
Connector B
Connector B
Connector B Connector B
Connector C
Connector C