GReddy e-Manage Ultimate Installation Manual - Manual (Page 17)

16
10. Injector Signal Wires
# E
Ч Ч Ч
When changing I/J CH
Example: Changing group injection to sequential injection
How to connect
• Connect the necessary I/J CH OUT wires to
the Connector C.
• The I/J CH Setting must be configured with
PC before starting the engine.
• Confirm the injector wiring to match the
injection method.
Sub Injector Wiring
When using the CH for sub injectors
Connect to
desired CH
When using high resistance injectors
When using low resistance injectors
Dropping
Resistor
When using low resistance injectors, dropping resistors are required to control the injectors.
Important
Female connector
Male connector
Splice
ECU
(Engine Control Unit)
Light Blue/Red (I/J CH- 6 IN)
Pink/Red (I/J CH- 5 IN)
Purple/Red (I/J CH- 4 IN)
Black/Red (I/J Ground)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
Blue/Red (I/J CH- 1 IN)
Orange/Red (I/J CH- 2 IN)
Yellow/Red (I/J CH- 3 IN)
Injector
Connector B
Connector B
Connector C