DAVIS New Anemometer Design for Vanatage Pro2 - Manual (Page 2)

Page 3:
In the list of parts, ignore the “drip ring.” It is now molded into the
housing.
Page 4:
Refer to this illustration when attaching the wind cups.
Tighten set
screw with
Allen wrench
Push cups onto
stainless steel
shaft
Attaching the Wind Cups
3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
®
Document No. 07395.273 Rev A February 6, 2013
©2013 Davis Instruments Corp. All rights reserved.
Vantage Pro is a registered trademark of Davis Instruments Corp. Hayward, CA.
Page 3:
In the list of parts, ignore the “drip ring.” It is now molded into the
housing.
Page 4:
Refer to this illustration when attaching the wind cups.
Tighten set
screw with
Allen wrench
Push cups onto
stainless steel
shaft
Attaching the Wind Cups
3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
®
Document No. 07395.273 Rev A February 6, 2013
©2013 Davis Instruments Corp. All rights reserved.
Vantage Pro is a registered trademark of Davis Instruments Corp. Hayward, CA.