DAVIS Surge Protector - Manual (Page 2)

Product Numbers: 7767
Davis Instruments Part Number: 7395-118
Surge Protector
Rev. B Manual (7/8/99)
This product complies with the essential protection requirements of the EC EMC
Directive 89/336/EC.
© Davis Instruments Corp. 1998. All rights reserved.
A TTACHING THE C ABLES TO THE S URGE P ROTECTOR
1. Pass the cables through the access holes in the base of the shelter being used.
Consult the shelter’s instruction manual for details.
2. Loosen the top hex nut on each post of the surge protector.
3. Place a wire from one cable between the first and second washers as shown below.
Bend the conductor around the screw post.
4. Place the same colored wire from the other cable between the second and third wash-
ers as shown below.
Bend the conductor around the screw post.
5. Tighten the hex nut until the wires are held securely in place.
A TTACHING W IRES TO S URGE P ROTECTORS
6. Repeat this procedure for each wire and each post on the surge protector.