DAVIS Shelter Heaters - Manual (Page 10)

Page 10 Heater
6. Bend each bare wire into a U-shape and secure under a screw head on the ter-
minal block, as shown below.
It does not matter which wire goes to each screw as long as only one wire
goes to each screw.
P OWER U NIT TERMINAL B LOCK
7. To provide strain relief for the cable, place a cable tie around the cable just
inside the hole through which this cable is running as shown below.
You may need to cut off the excess cable tie in order to close the power unit.
P ROVIDING S TRAIN R ELIEF
8. Replace the base of the power unit.
9. You may now plug the wall transformer into an outlet.
10.To insure that the heater is working, you may want to set the power unit to the
“ON” setting and then go to the Rain Collector to insure that the heater ele-
ment is hot.
DO NOT TOUCH THE HEATER ELEMENT OR ANY METALLIC POR-
TION OF THE HEATER.
You should be able to feel the heat at a short dis-
tance from the heater element.