DAVIS Cable Coupler Kit - Manual (Page 4)

Coupler Kit; for use with Standard 4-Connector Cables Product Number 7957
07395.010 Rev. D, October 12, 2011
This product complies with the essential protection requirements of the EC EMC Directive
2004/108/EC.
© Davis Instruments Corp. 2011. All rights reserved. Information in this document subject
to change without notice. Davis Instruments Quality Management System is ISO 9001 cer-
tified.
3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.
510-732-9229 • Fax: 510-732-9188
E-mail: [email protected] • www.davisnet.com
®
9. Gather the wires and splice
connectors neatly together
and enclose the in the two
halves of the protective
shell as shown below.
Use the #4 x ½” (12.5 mm)
screws to join the two
halves.
To Connect the Cables Using the Coupler
1. Place the cable plug at the end of one of the cables into one end of the coupler.
2. Place the cable plug at the
end of the other cable into the
other end of the coupler.
3. Enclose the connection in the
two halves of the protective
shell.
Use the #4 x ½” (12.5 mm)
screws to join the two halves.