DAVIS Temperatur/Humidity Sensor for GroWeather, EnviroMonitor, & Weather Monitor - Manual (Page 2)

Page 2 Standard & Industrial External Temperature/Humidity Sensor
Testing the T/H Sensor
Be sure to test the sensor before installing it.
1. Attach the sensor cable to the appropriate connector on the junction box/
sensor interface module (SIM). Refer to the T/H Sensor installation infor-
mation shown below and on the following pages.
2. Press the appropriate key on your console as necessary to make sure you
are getting an outside air temperature reading on the console.
3. Press the appropriate key on your console as necessary to make sure you
are getting an outside humidity reading on the console.
Installing the T/H Sensor
Follow the instructions in this section to install your sensor. Make sure you
read “Choosing a Location for the T/H Sensor” on page 4 as it contains impor-
tant information concerning placement of the sensor.
Typical Weather Monitor II Installation
The illustration below shows a typical T/H Sensor installation for the Weather
Monitor II.
Typical Weather Monitor II installation