Pc 5150, Rmc 7150 – Acnodes RMC 7150 User Manual

Page 16

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 5150

15-inch touch panel PC

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

RMC 7150

14” short depth rack server

3.3 Control Panel LEDs

The control panel located on the front of the RMC 7150 chassis has five LEDs. These LEDs provide you with critical information

related to different parts of the system. This section explains what each LED indicates when illuminated and any corrective

action you may need to take.

Overheat/Fan Fail

When this LED flashes it indicates a fan failure. When on continiously (on and not flashing) it indicates an overheat condition,

which may be caused by cables obstructing the airflow in the system or the ambient room temperature being too warm. Check

the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that

the chassis covers are installed. Finally, verify that the heatsinks are installed properly. This LED will remain flashing or on as

long as the overheat condition exists.

Indicates network activity on LAN2 when flashing.

Indicates network activity on LAN1 when flashing.

Channel activity for HDDs. This light indicates IDE drive activity when flashing.

Indicates power is being supplied to the system’s power supply units. This LED should normally be illuminated when the

system is operating.